Brake Riveting Tool
A perfect job every time is assured with this riveting tool.
Two dies are supplied, one for removing old rivets and one for fitting the new ones.
Manufactured from machined steel, this tool will not wear out.
|
Draper Mini High Temperature Gas Torch
Ideal for softening old Loctite prior to removing bolts.
Instant electronic ignition
Windproof controlable flame
Up to 20 minutes on a fill of lighter butane
Flame temp up to 1300 deg C
Very compact for use in cramped spaces
Sorry temporarily out of stock
|
| |
Perspex Drills
Specially ground point, 60° included tip angle, 0°rake angle, shoulder relieved, for drilling Perspex to prevent fractures, chipping or cracking.
|
Imperial HSS Twist Drills
Replace the drills you have broken or lost from this selection of loose bits. All 75p except where marked.
All manufactured to the highest international standards set by DIN 338 and ISO 235/1.
|
| |
Draper 4-24mm Taper Cutter
Make holes from 4mm to 24mm diameter. Suitable for use with power drills on thin mild steel, aluminium and fibreglass. A very versatile tool.
|
Sealey Angle Driver
I wish I had known about this tool when I was building my Jabiru. The angle driver is powered by a drill or driver and allows you to drill or screw round corners. Takes 6mm hex bits and socket adaptors. Magnetic retention. Lifetime guarantee
|
| |
Lock Wire Pliers - 5 metres of locking wire FREE
These pliers are 6" long and are very good value for money. Jaws are manufactured from chrome vanadium steel and are hardened and tempered for long life.
NOW WITH 5 metres FREE LOCK WIRE
|
10 Piece Draper Imperial ball end Hex Key set
Made from chrome vanadium steel, these hex keys are long reach with a ball end. This allows up to 30 degrees of tilt for those awkward, hard to get at, bolts, like some of the Jabiru exhaust flange fittings.
1/16" 5/64" 3/32" 1/8" 5/32" 3/16" 7/32" 1/4" 5/16" 3/8" all on a handy clip
|
| |
